guzzik
Freebander
Registered: 08-2010
Posts: 38
Karma: 0 (+0/-0)
|
Reply | Quote
|
|
Re: Ham Jumbo 2.................................??
Hi Mark...........Seems it was a filthy board under another board...........Where the TOSO12AOX board is, under that is the TX/RX switching area, seems it was manky. The Audio has held up quite good over a two hour soak test of keying and recieving.......Ve shall see vhat ve shall see.
|
5/Jan/2011, 10:01 pm
|
Link to this post
Send Email to guzzik
Send PM to guzzik
Blog
|
madmark1
Accomplished DX-er
Registered: 10-2009
Location: Abertillery
Posts: 454
Karma: 9 (+9/-0)
|
Reply | Quote
|
|
Re: Ham Jumbo 2.................................??
Nice 1, Glad you have it up and running. I hope it holds up.
Mark
--- http://www.youtube.com/MrMadjones
http://gw0wvl.weebly.com/
|
5/Jan/2011, 10:25 pm
|
Link to this post
Send Email to madmark1
Send PM to madmark1
Blog
|
guzzik
Freebander
Registered: 08-2010
Posts: 38
Karma: 0 (+0/-0)
|
Reply | Quote
|
|
Re: Ham Jumbo 2.................................??
So do I!!!!!!!!!!!!!!!!!!!!!
|
5/Jan/2011, 10:34 pm
|
Link to this post
Send Email to guzzik
Send PM to guzzik
Blog
|
guzzik
Freebander
Registered: 08-2010
Posts: 38
Karma: 0 (+0/-0)
|
Reply | Quote
|
|
Re: Ham Jumbo 2.................................??
Nope..............It didn't............I have given up on it for now.........Now for the President Lincoln with VERY low audio................Sheesh....
|
7/Jan/2011, 10:12 am
|
Link to this post
Send Email to guzzik
Send PM to guzzik
Blog
|
YT2095
Freebander
Registered: 12-2010
Location: the Black Country
Posts: 188
Karma: 1 (+1/-0)
|
Reply | Quote
|
|
Re: Ham Jumbo 2.................................??
is the audio going into the Pot being affected at all?
it`s usually one of the outer 2 lugs, GND being the other side. then test the Center lug to make sure it`s coming Out the pot ok.
you`ll need an external amp and spkr for this test though.
try and trace it to the audio chips Input and see if you Keying alters the sound there too.
if it still works but not from the radios speaker then your radio`s fine in itself it`s a simple audio only problem After the chip, and there`s not much complicated going on after.
--- I`m also on Twitter as "YT2095" ;)
|
7/Jan/2011, 3:51 pm
|
Link to this post
Send Email to YT2095
Send PM to YT2095
Blog
|